HP P2055 not printing either from PC or directly on printer

HP P2055 not printing either from PC or directly on printer

This requires a NVRAM reset. To do so on your HP P2055 perform the following steps:

1. Turn the product off.

2. Simultaneously press and hold the up arrow and Cancel button

3. Turn on the product.

4. When the message Permanent storage init displays, release the buttons. When the NVRAM initialization is completed, the product goes to a Ready state.


This should now restore your HP P2055 to its usual self. Try a test print directly from the printer by printing a configuration report or a test print through your PC

    • Related Articles

    • Receipt Printer Printing Blocks and Random Characters

      Is your receipt printer printing similar to the receipt on the right? There is a simple fix that requires changing something known as the baud rate of the printer. Please follow the steps below to sort this issue: 1. Turn off the receipt printer 2. ...

    • Printing Zone Labels from Label Printer

      To be able to print zone labels through the label printer, please follow these steps and use the screenshot for guidance: Choose your prefix and number of labels you need, then click generate This will populate the blank box below Next select your ...

    • Receipt Printer Working but Cash Drawer not Opening

      1. Turn off the receipt printer 2. Turn the receipt printer back on by holding down the power button and feed button at the same time on the front of the receipt printer until it does a print out 3. Once it has done this print out press the feed ...

    • Label Printer Settings for Toshiba SA4

      Please see below the correct settings of the SA4 Toshiba Label printer. Firstly make sure the correct label printer is selected TEC452/SA4 The labels should be selected as the ones highlighted below (2 across (37 by 24mm, 3mm gap)) Also ensure the ...

    • Setting Up SA4 via Network

      Youtube Video Tutorial: Setting Up SA4 Label Printer via Network  In Vector, rather than configure the printer to look at LTP or COM, enter the IPaddress:portnumber (The IP address can be set on the printer by following the attached document)